I have hundreds of reloads for every caliber I own and will likely not hunt through my stock. I know this is a "kak" attitude to have, but h...

Some time ago I touched on using compressed air .. the pressure needed for complete forming I discovered was 12,000 psi ( 828 Bar )This idea caused a ...

SAAMI chamber print can be found hereAmerican National Standards Published by SAAMICIP chamber print can be found hereCOMMISSION INTERNATIONALE PERMAN...

If I use the GSC method I should be able to get a case sized to the actual specs of my chamber. Then, if I were to compare that to SAAMI specs, I shou...

Its is so to say a way of finding out if you need to or not have measurements done professionally. Purchase the right gauges and measuring instruments...

I know of two cases in the Vaal Triangle where the licensed owner had to take preventative steps and employ a lawyer to counter false accusations. One...

My weekly look at shooting matters in Britain.I gather the "punch-line" starts at 14:15 ?  police taking guns ?Read through a bit and y...

Die set up will fix incorrect die set up issues, you not going to fix head spacing with die set up - perhaps reduce its apparent resultant showings, b...

From the OP I surmised that there was something not correct beyond the normal scenario of setting head-space by FL sizing die when reloading ?Somethin...

Think about what it took to make them ? How much / many scarce resources were used upAlways the German problem .. bigger is betterRussians understood ...

In searching for possible reasons for the headspace problem with my 308, Do you have standard to spec ( SAAMI or CIP ) GO and NOGO gauges for your rif...

NoAny idea then what could be the cause of DsJ's headspace problem ? ???